Better Info
Thank you all for your input I will gladly respond to all your comments soon. Yesterday after a heavier cleaning (not fully cleaned yet) I wanted to prove or remove My doubts about a possible very thin lamination at the barrel lug It is now showing the slice pattern well. First I used sanding to clean and remove black spots and rust with WD 40 and commercial fiber pads manually. I did resort to a Dremel tool with identical pads on the fluted muzzle with the best effect so far for displaying the design. I'm certain now it is not an etched on effect. I etched the barrels front half after more aggressive scrubbing with pads. Scoping the bore shows the chamber restrictor showing perhaps an area where weld may be incomplete. My scanner and Pc are not on good terms. Dr. Figiel mentions different slice depths for the spiral and orange slice portions he suggests they were cut nearly thru in two directions and layed out flat side by side for forging.,
|
10th February 2018, 02:50 AM
Threaded Mode