![]() |
|
![]() |
#1 |
EAAF Staff
Join Date: Dec 2004
Location: Louisville, KY
Posts: 7,310
|
![]()
I was luck - it was already polished. Just had to use acetone to get off the old oils. then I etched the blade and limed the hilt.
Also I forgot that it could also be from the late 1700s during the Indian Mutiny. |
![]() |
![]() |
![]() |
#2 |
Vikingsword Staff
Join Date: Dec 2004
Location: The Aussie Bush
Posts: 4,453
|
![]()
Very nice kukri! Congrats.
|
![]() |
![]() |
![]() |
#3 |
Member
Join Date: Dec 2004
Location: Kernersville, NC, USA
Posts: 793
|
![]()
What an outstanding piece. Congrats!
Steve |
![]() |
![]() |
![]() |
#4 |
Member
Join Date: Apr 2019
Posts: 102
|
![]()
This is a nice kukri that I would put to the Indian Mutany period based on other similar kukri with steel hilt, full tang peened arrangement, fullering and laminated steel. 1857–59 or there about.
"Indian Mutiny, also called Sepoy Mutiny or First War of Independence, widespread but unsuccessful rebellion against British rule in India in 1857–59. Begun in Meerut by Indian troops (sepoys) in the service of the British East India Company, it spread to Delhi, Agra, Kanpur, and Lucknow." Didn't bid on this one as I have another two inbound. |
![]() |
![]() |
![]() |
#5 |
Member
Join Date: Aug 2007
Location: Germany, Dortmund
Posts: 9,272
|
![]()
Hi Jose,
Very nice piece! Blade is after my fancy too dark etched, or too strong, I would repolish the blade a little bit. Anyway, congrats! Regards, Detlef |
![]() |
![]() |
![]() |
#6 |
Member
Join Date: Sep 2014
Location: Austria
Posts: 1,911
|
![]()
Very good and rare aquisition!
![]() However, this is not a kris so the etching should be very discrete... if any. I suspect it was over-etched to make the pattern discernable in the photos, and facilitate the sale. So, I agree with Detlef and suggest you polish it a little. The pattern should be only visible in reflected light. |
![]() |
![]() |
![]() |
#7 |
EAAF Staff
Join Date: Dec 2004
Location: Louisville, KY
Posts: 7,310
|
![]()
Thanks folks.
I will go back and repolish and re-etch the blade to where it won't be so dark and a little more subtle. Also I'll also get back to you on the measurements as well. |
![]() |
![]() |
![]() |
|
|