Indonesian blade ?

David R · 26th August 2019, 05:55 PM

Thank you for responding, being a bit of an obsessive the subject of traditional oils and maintenance interest me. Would this be a good choice for a Keris?... While googling found a conversation here about that very thing. Time to get some nice oils I think.

rockelk · 27th August 2019, 03:26 AM

Yes the shipper was also negligent also. In fact he returned my purchase, quite admirable. I used to run a metallurgical lab. I looked up the arsenic etching procedure, it doesn't appear that complicated, just done with lots of awareness and caution in a remote area. Did I miss something or is there more unsaid, akin to the Black Arts? With Regards.

A. G. Maisey · 27th August 2019, 04:28 AM

Getting hold of lab. quality arsenic trioxide is not easy. A way around arsenic trioxide can be found by using realgar, but there is no consistency in realgar and you could buy and try a number of lots of realgar and still not get a satisfactory result.

Learning a correct process can be learnt by anybody with patience.

Knowing what the item should look like when finished probably takes around 5 to 10 years of daily exposure to pamor blades to learn.

To go to the trouble of learning how to get even a passable result for one pedang blade is in my opinion pretty much a waste of time. On the other hand, if your collecting interests are pointing in the direction of S.E. Asia and pamor blades, it could be time well spent.

26th August 2019, 05:55 PM	#1
David R Member Join Date: Jan 2011 Posts: 1,134	Thank you for responding, being a bit of an obsessive the subject of traditional oils and maintenance interest me. Would this be a good choice for a Keris?... While googling found a conversation here about that very thing. Time to get some nice oils I think. Last edited by David R; 26th August 2019 at 06:16 PM.

27th August 2019, 03:26 AM	#2
rockelk Member Join Date: May 2019 Location: Arizona Posts: 42	Thanks to all Yes the shipper was also negligent also. In fact he returned my purchase, quite admirable. I used to run a metallurgical lab. I looked up the arsenic etching procedure, it doesn't appear that complicated, just done with lots of awareness and caution in a remote area. Did I miss something or is there more unsaid, akin to the Black Arts? With Regards.

27th August 2019, 04:28 AM	#3
A. G. Maisey Member Join Date: May 2006 Posts: 7,084	Getting hold of lab. quality arsenic trioxide is not easy. A way around arsenic trioxide can be found by using realgar, but there is no consistency in realgar and you could buy and try a number of lots of realgar and still not get a satisfactory result. Learning a correct process can be learnt by anybody with patience. Knowing what the item should look like when finished probably takes around 5 to 10 years of daily exposure to pamor blades to learn. To go to the trouble of learning how to get even a passable result for one pedang blade is in my opinion pretty much a waste of time. On the other hand, if your collecting interests are pointing in the direction of S.E. Asia and pamor blades, it could be time well spent.