Introduction

A. G. Maisey · 3rd February 2017, 10:42 PM

I'd be prepared to accept the way in which the lines of pamor are aligned as OK, not good, not a master's work, but acceptable.

The fact that the weld joint does not run with the odo-odo is something that is less than good, but a less than expert smith can still be capable of technically proficient work.

The thing I cannot regard as acceptable is the poor weld joint running between the two pieces of twisted pamor. This joint is not technically proficient.

3rd February 2017, 10:42 PM	#10
A. G. Maisey Member Join Date: May 2006 Posts: 6,992	I'd be prepared to accept the way in which the lines of pamor are aligned as OK, not good, not a master's work, but acceptable. The fact that the weld joint does not run with the odo-odo is something that is less than good, but a less than expert smith can still be capable of technically proficient work. The thing I cannot regard as acceptable is the poor weld joint running between the two pieces of twisted pamor. This joint is not technically proficient.