Quality of edged weapons (101)?

A. G. Maisey · 7th September 2014, 02:29 AM

Yes, a lot of people do not understand that often the only way to get the information or knowledge that one requires is to ask precise, specific questions.

This way the information can be tailored to the level that the person asking the question is ready to accept and understand. Give too much info, it gets lost, give too little and it gets lost. Ask the right question and hopefully the info given is just sufficient.

I don't have any pics of western style knives that I made, I still have a couple of these, but cannot immediately put my hand on them, I do have a very large quantity of damascus blades that I made, but again, no pics, however, here is a link to a page in my site, if you scroll down a bit there are 2 or 3 keris blades that I made a few years ago:-

http://www.kerisattosanaji.com/PBXIIempus.html

7th September 2014, 02:29 AM	#18
A. G. Maisey Member Join Date: May 2006 Posts: 6,992	Yes, a lot of people do not understand that often the only way to get the information or knowledge that one requires is to ask precise, specific questions. This way the information can be tailored to the level that the person asking the question is ready to accept and understand. Give too much info, it gets lost, give too little and it gets lost. Ask the right question and hopefully the info given is just sufficient. I don't have any pics of western style knives that I made, I still have a couple of these, but cannot immediately put my hand on them, I do have a very large quantity of damascus blades that I made, but again, no pics, however, here is a link to a page in my site, if you scroll down a bit there are 2 or 3 keris blades that I made a few years ago:- http://www.kerisattosanaji.com/PBXIIempus.html