...and while were on the topic of pole arms.....

[fernando]

Maybe props for movies or the like

[Shakethetrees]

Originally Posted by fernando

Maybe props for movies or the like

I'm not sure of this. I've seen a lot of movie props, and most of them are either molded plastic, or, if they're metal, they might look good from afar, but close up, there's no mistaking them for props.

Besides, they show some age.

These guys are sharp enough to where you should be careful not to stumble into them or otherwise come into surprise contact. They'll cut or poke a good size hole in you if you're careless.

I suspect they're 19th century copies made for a manor house, or something similar.

[fernando]

Originally Posted by Shakethetrees

...These guys are sharp enough to where you should be careful not to stumble into them or otherwise come into surprise contact. They'll cut or poke a good size hole in you if you're careless.
... I suspect they're 19th century copies made for a manor house, or something similar.

Well, things put that way, you are most probably right

[JamesKelly]

Just a metallurgical aside.

"Cast iron cannot be wrought and wrought iron cannot be cast."

This was a true saying through the 19th century, at least in the Western World.
Steel takes something over 1430C (2600F) to melt, cast iron maybe 200-250C (400-450F) lower. A somewhat ductile form of cast iron, "Malleable Iron" was developed in 18th century France. It would not be suitable for any axe or spear, it is not that tough.

Michigan Steel Cast Company was organized in 1908 in Detroit, I believe MISCO was a rather early steel foundry.