Armour?

rasdan · 10th September 2005, 12:36 PM

Hi Ahriman,

I think the the wire diameter of 2.5mm (12ga if i'm right) is too big and ring diameter also is a bit large. What i see normally in a Moro armour they would use a 14ga wire with a diameter of 5/16" for the suit and 12ga wire with a diameter of perhaps 3/8" for rings connecting the plates. The plates are also a bit thick. I thought 2.5mm thick would be adequate. But, well, this is only my observations, i dont have the experience of making one myself.

Btw, i have a few questions. Do u cut your rings by yourself? What material is the rings? Can u please tell us, how do u make the plates curve? Do u use a stamping machine or a hammer?

Regards,
Rasdan

10th September 2005, 12:36 PM	#7
rasdan Member Join Date: Dec 2004 Location: Kuala Lumpur Posts: 368	Hi Ahriman, I think the the wire diameter of 2.5mm (12ga if i'm right) is too big and ring diameter also is a bit large. What i see normally in a Moro armour they would use a 14ga wire with a diameter of 5/16" for the suit and 12ga wire with a diameter of perhaps 3/8" for rings connecting the plates. The plates are also a bit thick. I thought 2.5mm thick would be adequate. But, well, this is only my observations, i dont have the experience of making one myself. Btw, i have a few questions. Do u cut your rings by yourself? What material is the rings? Can u please tell us, how do u make the plates curve? Do u use a stamping machine or a hammer? Regards, Rasdan