Khyber Knife Restoration

Battara · 10th February 2011, 04:35 AM

Thank you Robert.

I used precast silver pieces and carefully drilled holes into them. Then I used thick silver wire and very carefully and delicately balled the ends that stood out above the silver pieces with a blow torch while on the hilt. The pin is made of brass where I flattened the ends.

The finial ring I made out of a solid piece of silver ingot. Here is a picture of it in progress:

A.alnakkas · 10th February 2011, 07:41 AM

Beautiful work

Battara · 11th February 2011, 06:36 PM

Thank you. I enjoy working on pieces like this (as well as Filipino/Moro stuff).

10th February 2011, 04:35 AM	#1
Battara EAAF Staff Join Date: Dec 2004 Location: Louisville, KY Posts: 7,363	Thank you Robert. I used precast silver pieces and carefully drilled holes into them. Then I used thick silver wire and very carefully and delicately balled the ends that stood out above the silver pieces with a blow torch while on the hilt. The pin is made of brass where I flattened the ends. The finial ring I made out of a solid piece of silver ingot. Here is a picture of it in progress: Attached Images

10th February 2011, 07:41 AM	#2
A.alnakkas Member Join Date: Nov 2010 Location: Kuwait Posts: 1,340	Beautiful work

11th February 2011, 06:36 PM	#3
Battara EAAF Staff Join Date: Dec 2004 Location: Louisville, KY Posts: 7,363	Thank you. I enjoy working on pieces like this (as well as Filipino/Moro stuff).