|
|
|||||||
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
17th October 2010, 03:12 PM
|
#1 |
|
Member
Join Date: Sep 2008
Location: PR, USA
Posts: 679
|
Began the cleaning. Added the Pineapple juice yesterday. Tube seems to hold the juice sans leaking. So far, so good!
|
|
|
|
17th October 2010, 03:24 PM
|
#2 |
|
Vikingsword Staff
Join Date: Nov 2004
Posts: 6,348
|
Now comes the patience part ...
 Check every day or so and remove anything that has softened . The solution will get very funky after a while . |
|
|
|
|
17th October 2010, 11:51 PM
|
#3 |
|
Member
Join Date: Sep 2008
Location: PR, USA
Posts: 679
|
Bad luck, the tube's end became unglued, and the Pineapple Juice ended up spilt on the floor.
New attempt has been made to glue it back with a stronger glue. Will try with new PJ in a couple hours. Wish me luck! 
|
|
|
|
|
18th October 2010, 01:22 AM
|
#4 |
|
Vikingsword Staff
Join Date: Nov 2004
Posts: 6,348
|
Silicone caulk .
|
|
|
|
|
18th October 2010, 03:38 AM
|
#5 | |
|
Member
Join Date: Sep 2008
Location: PR, USA
Posts: 679
|
That's what failed!
Now I'm using "hard-as-nails", let's see. : ) Quote:
|
|
|
|
|
|
18th October 2010, 04:11 AM
|
#6 |
|
Vikingsword Staff
Join Date: Nov 2004
Posts: 6,348
|
Oh dear ...
|
|
|
|
|
18th November 2010, 04:26 PM
|
#7 | |
|
Member
Join Date: Sep 2008
Location: PR, USA
Posts: 679
|
Didn't work either, eventually a hole was created through the glue itsel,and the PJ ended up in the floor. I then used the old tomato paste trick, and followed with a brass brush and fine grit sand paper/ wire-mesh. Then waxed the blade. Here's the result so far:
Quote:
|
|
|
|
|
|
|
|
Hybrid Mode
