An early English dog lock musket

[M ELEY]

Hello Rick,

In regards to the hole between the hammer and catch, yes, it appears to be threaded. On the direct opposite side of the lock, corresponding to where this "screw" would thread through, there is a very small hole in the wood. I'm assuming this is where it would have threaded through if it were ever accessed? (it never was, apparently). I'll take that last picture soon and thanks again-
Mark

[rickystl]

Originally Posted by M ELEY

Hello Rick,

In regards to the hole between the hammer and catch, yes, it appears to be threaded. On the direct opposite side of the lock, corresponding to where this "screw" would thread through, there is a very small hole in the wood. I'm assuming this is where it would have threaded through if it were ever accessed? (it never was, apparently). I'll take that last picture soon and thanks again-
Mark

Hi Mark.

OK. So the lock itself was built to accept three plate screws, as would be common for these early locks. For whatever reason, who ever assembled the gun felt it unessesary to use the third screw. Or didn't have one available LOL
The two plate screws and the tiny screw on the outside of the lock plate tail being sufficient. With the exception of the tiny hole you mention, there doesn't seem to be any evidence of it ever having the third hole. Curious.

Anyway. If you can, a photos of the lock interior would be really interesting.

Thanks, Rick.