Method of displaying swords

[Ken Maddock]

Hi Stu
I just cut slots very precisely and a friction fit holds them in
The khanda is not in too tight, but the tulwar is "on top" so that holds the khanda in
As the tulwar is slightly wider as you go up the blade from the handle I could introduce it into the slot closer to the handle and draw back till wider section of the blade was in contact with the walls of the slot
Bit hard to explain but I hope you get idea
As the metal is soft copper there is no blade damage
I would like to acquire a shield and mount over to finish off the display
All the best
Ken