Which kind of steel is this ?

Martin Lubojacky · 22nd October 2014, 07:25 AM

The blade (cca 60 cms long and originally very rusty), was mechanically cleaned, plunged into disodium salt of EDTA and again cleaned with a very fine steel brush, than cleaned in demi water and treated wit silicon oil.

I think the steel is not mechanical damascus, actually, I don´t know what to think about it. If I cleaned it too much deep, the structure(design) disappeared on some places (tip and near the tip). What is this ? I heard such design could be result of tempering (quenching), but I am not sure. (the handle is original except of the central rhomb rivet which is new).

ALEX · 22nd October 2014, 08:38 AM

Martin, I do not see/think it has any particular pattern, although I see one weak streak, but hard to tell. extensive pitting and mechanical cleaning do weaken the pattern and make it harder to etch.

Iain · 22nd October 2014, 09:59 AM

I have to say it looks like mono steel to me, simply exhibiting aging due to exposure to dust/dirt etc.

Gavin Nugent · 22nd October 2014, 12:56 PM

The type is known to have a twist core centre within the very narrow fullers but nothing gives it away if it is there.

Oliver Pinchot · 22nd October 2014, 04:07 PM

These blades are often layered, which etching may reveal. But it isn't an intentional pattern-weld. I'd leave it as is or perhaps clean lightly.

22nd October 2014, 07:25 AM	#1
Martin Lubojacky Member Join Date: May 2008 Location: Czech Republic Posts: 836	Which kind of steel is this ? The blade (cca 60 cms long and originally very rusty), was mechanically cleaned, plunged into disodium salt of EDTA and again cleaned with a very fine steel brush, than cleaned in demi water and treated wit silicon oil. I think the steel is not mechanical damascus, actually, I don´t know what to think about it. If I cleaned it too much deep, the structure(design) disappeared on some places (tip and near the tip). What is this ? I heard such design could be result of tempering (quenching), but I am not sure. (the handle is original except of the central rhomb rivet which is new). Attached Images

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

22nd October 2014, 08:38 AM	#2
ALEX Member Join Date: Jan 2006 Posts: 935	Martin, I do not see/think it has any particular pattern, although I see one weak streak, but hard to tell. extensive pitting and mechanical cleaning do weaken the pattern and make it harder to etch.

22nd October 2014, 09:59 AM	#3
Iain Member Join Date: Mar 2010 Location: Olomouc Posts: 1,680	I have to say it looks like mono steel to me, simply exhibiting aging due to exposure to dust/dirt etc.

22nd October 2014, 12:56 PM	#4
Gavin Nugent Member Join Date: Oct 2007 Posts: 2,818	The type is known to have a twist core centre within the very narrow fullers but nothing gives it away if it is there.

22nd October 2014, 04:07 PM	#5
Oliver Pinchot Member Join Date: Sep 2012 Posts: 456	These blades are often layered, which etching may reveal. But it isn't an intentional pattern-weld. I'd leave it as is or perhaps clean lightly.