How to disconnect the handle of a tulwar?

RhysMichael · 23rd December 2006, 02:54 PM

It seems most resins fail at about 200 degrees. I do not know what type of handle it is and how that would effect any koftgari and such. Phillip or Jose would be the people to ask about that. That temperature should not affect the blade. I have read that boiling water will work but other sources tell me it is not hot enough. Some tulwar hilts have a pin running through the tang, near or between the "quillions" but usually they are held together solely by the adhesive Ariel can probably be much more help on this

If you cannot get the original here is a recipe for cutlers resin

http://blackpowderonline.com/cutlrsresin.htm

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

23rd December 2006, 02:54 PM	#4
RhysMichael Member Join Date: Dec 2004 Location: Virginia Posts: 520	It seems most resins fail at about 200 degrees. I do not know what type of handle it is and how that would effect any koftgari and such. Phillip or Jose would be the people to ask about that. That temperature should not affect the blade. I have read that boiling water will work but other sources tell me it is not hot enough. Some tulwar hilts have a pin running through the tang, near or between the "quillions" but usually they are held together solely by the adhesive Ariel can probably be much more help on this If you cannot get the original here is a recipe for cutlers resin http://blackpowderonline.com/cutlrsresin.htm