Transporting swords

Mare Rosu · 3rd December 2004, 09:52 PM

I have like VANDOO used what he used.
I also have used thin wall ( less weight ) PVC in the 3"-4" diameter size, and the length needed, using PVC solvent on the cap on one end and friction fit an end cap on the other end, then tape it closed. With the sword wrapped in bubble wrap then filled the tube with "peanuts" around the sword. You could just about drive a car over the the tube without damaging the sword.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

3rd December 2004, 09:52 PM	#5
Mare Rosu Deceased Join Date: Dec 2004 Location: USA, DEEP SOUTH, GEORGIA, Y'all hear? Posts: 121	I have like VANDOO used what he used. I also have used thin wall ( less weight ) PVC in the 3"-4" diameter size, and the length needed, using PVC solvent on the cap on one end and friction fit an end cap on the other end, then tape it closed. With the sword wrapped in bubble wrap then filled the tube with "peanuts" around the sword. You could just about drive a car over the the tube without damaging the sword.