![]() |
|
![]() |
#1 | |
Member
Join Date: Jun 2015
Location: Minneapolis,MN
Posts: 350
|
![]() Quote:
Am I right to be so? Thanks, Leif |
|
![]() |
![]() |
![]() |
#2 |
Member
Join Date: May 2006
Posts: 7,017
|
![]()
In Australia we call the limes that I use "Tahitian limes". At the moment I do not have a tree, but I did have a tree 20 years ago, the tree was sold to me as a Tahitian Lime, in the supermarkets fruit that was the same as on my tree was called "Tahitian Lime".
In Jawa limes that appear to be exactly the same as this are called jeruk nipis. In appearance the fruit is round, about the same size as a large egg, very green. Taste is more acidic than a lemon. I do not know what Persian limes are. |
![]() |
![]() |
![]() |
#3 |
Member
Join Date: May 2006
Posts: 7,017
|
![]()
Ariel, re Beefeater gin.
Bet you didn't know that many "pure fruit juice" products on the market are processed with an extract made from beef and with alcohol, did you? Basically a lot of this stuff is not halal. Before consumption check with the manufacturer if this is a concern to you. |
![]() |
![]() |
![]() |
#4 | |
Member
Join Date: Aug 2007
Location: Germany, Dortmund
Posts: 9,214
|
![]() Quote:
don't think that you need to be skeptical, a few days ago I've seen at tv a documentation, it will be Persian lime. Regards, Detlef |
|
![]() |
![]() |
![]() |
#5 |
Member
Join Date: May 2006
Posts: 7,017
|
![]()
Jean, I've tried stronger vinegar, here they label it as cleaning vinegar.
What I have found is that when the material of the blade is good, dense material, well compacted and with a relatively smooth surface, the stronger vinegar does give a faster result, however, when the material is of lesser quality and not smooth and compacted the stronger vinegar tends to leave the blade looking like a sponge. The time taken to clean is immaterial to me. In the past , with pineapple juice I would sometimes take 2 weeks or moreto thoroughly clean a blade, and perhaps renew the juice several times during the process, especially in summer. I like the process to proceed slowly because it is easier to control. The brushes I use are old tooth brushes, hard is better, but I usually use soft brushes, because that's what gets used in the house. I do not use metal brushes, and frankly I consider them unnecessary, because the vinegar --- or whatever is being used --- softens the corrosion to the point where all that is required is relatively gentle brushing to remove the loose residue of the rust. Yes, I acknowledge that my process is slow, but it is very, very safe. |
![]() |
![]() |
![]() |
#6 | |
Member
Join Date: Jun 2009
Posts: 1,740
|
![]() Quote:
![]() Regards |
|
![]() |
![]() |
![]() |
#7 | |
Member
Join Date: Aug 2007
Location: Germany, Dortmund
Posts: 9,214
|
![]() Quote:
I think you have done it in the correct way, the blade was just to much corroded. But you have removed all rust what's important. The other blade you have shown look fine. Regards, Detlef |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|