....but is this ivory?

Green · 21st April 2016, 08:34 AM

David,

the hilt can be removed easily but it came off with the mendak so i could not do hot pin test at the base.

But I figured if the hilt is from resin material it doesn't really matter if it is destroyed by hot pin prick , so i decided to do a hot pin test on the black part of the hilt but it did not melt or gave any burnt mark. I felt quite good but then decided to do the same on one of my rencong hilts that I know was made from resin material. But the pin did not melt the resin either.

Apparently the resin can be very heat resistant or my pin was not hot enough.
So, still no conclusion and I'd leave it at that. Ignorance is bliss - as they say...

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

21st April 2016, 08:34 AM	#7
Green Member Join Date: Apr 2015 Location: Malaysia Posts: 321	David, the hilt can be removed easily but it came off with the mendak so i could not do hot pin test at the base. But I figured if the hilt is from resin material it doesn't really matter if it is destroyed by hot pin prick , so i decided to do a hot pin test on the black part of the hilt but it did not melt or gave any burnt mark. I felt quite good but then decided to do the same on one of my rencong hilts that I know was made from resin material. But the pin did not melt the resin either. Apparently the resin can be very heat resistant or my pin was not hot enough. So, still no conclusion and I'd leave it at that. Ignorance is bliss - as they say...