Help please. Japanese Gunto (Genuine ? ) with battlefield scabbard.

katana · 25th May 2011, 04:54 PM

Cleaned an area on the blade with very fine wet and dry paper using a very fine 1020 grade then (even finer) 2040 grade, lubricated with some olive oil.

First thing that was noticeable is there is a Hamon and its not a Chinese acid etched one !!! Its not regular but is a fine colour change in the steel

I also think there is 'activity' in the blade....impossible to photograph....but when reflecting direct sunlight the cleaned area glistens and sparkles...hard to explain but the blade seems to come to life as you gentle 'angle' it in the sunlight.... like it is covered in very fine glitter ...but when you look at the blade 'staight on' the 'metallic' sheen is gone

....not explaining this very well but hoping someone might understand the 'rambles' of this madman

There is a small, but noticeable, forging flaw which could explain why, if the blade is of some quality, it was not signed ??

Not certain what to do now...should I etch the newly cleaned area ????

I would be grateful for any advice, help or comments

Regards David

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

25th May 2011, 04:54 PM	#5
katana Member Join Date: Jan 2006 Location: Kent Posts: 2,658	Cleaned an area on the blade with very fine wet and dry paper using a very fine 1020 grade then (even finer) 2040 grade, lubricated with some olive oil. First thing that was noticeable is there is a Hamon and its not a Chinese acid etched one !!! Its not regular but is a fine colour change in the steel I also think there is 'activity' in the blade....impossible to photograph....but when reflecting direct sunlight the cleaned area glistens and sparkles...hard to explain but the blade seems to come to life as you gentle 'angle' it in the sunlight.... like it is covered in very fine glitter ...but when you look at the blade 'staight on' the 'metallic' sheen is gone ....not explaining this very well but hoping someone might understand the 'rambles' of this madman There is a small, but noticeable, forging flaw which could explain why, if the blade is of some quality, it was not signed ?? Not certain what to do now...should I etch the newly cleaned area ???? I would be grateful for any advice, help or comments Regards David