Mongolian? Knife/sword

Shakethetrees · 9th September 2014, 05:07 AM

Polished and etched!

I had a little time on my hands today and cleaned, polished and etched the blade.

I used some circuit board etching solution about 50/50 strength for about 30 minutes. Next I lightly wire brushed it by hand and applied a coating of Renaissance Wax to the lightly heated blade.

When it was room temp I buffed it by hand with a cloth to bring up a bit of luster.

This was my first try at blade etching, so comments and suggestions welcome!

9th September 2014, 05:07 AM	#4
Shakethetrees Member Join Date: Apr 2014 Location: Louisiana Posts: 363	Polished and etched! I had a little time on my hands today and cleaned, polished and etched the blade. I used some circuit board etching solution about 50/50 strength for about 30 minutes. Next I lightly wire brushed it by hand and applied a coating of Renaissance Wax to the lightly heated blade. When it was room temp I buffed it by hand with a cloth to bring up a bit of luster. This was my first try at blade etching, so comments and suggestions welcome! Attached Images