Kurdistan dagger

ALEX · 9th May 2008, 10:40 AM

RSWORD, Thank you for a great sum-up. I've learned a lot from you in the past, and it continues - always appreciate your knowledge and comments.
I agree - the pattern is sham, and FeCl will be a best bet. Sometimes, especially when etching Sham - the surface may turn yellowish. Adding little Nital (2% Nitric Acid solution) to FeCl will help to avoid it.

Also, a great question from Gonzalo. Was wootz produced by Kurds in Kurdistan? Kurdistan was/is part of Iraq, but Kurds historically lived in Iraq, Iran, Turkey and Syria. and wootz ores were discovered in Persia as well as in Iraq, so my quess is that wootz blades were part of Persian trade, and the fittings were added as part of local "customising". Does anyone has any references/comments about this?
Good luck to all.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

9th May 2008, 10:40 AM	#17
ALEX Member Join Date: Jan 2006 Posts: 936	RSWORD, Thank you for a great sum-up. I've learned a lot from you in the past, and it continues - always appreciate your knowledge and comments. I agree - the pattern is sham, and FeCl will be a best bet. Sometimes, especially when etching Sham - the surface may turn yellowish. Adding little Nital (2% Nitric Acid solution) to FeCl will help to avoid it. Also, a great question from Gonzalo. Was wootz produced by Kurds in Kurdistan? Kurdistan was/is part of Iraq, but Kurds historically lived in Iraq, Iran, Turkey and Syria. and wootz ores were discovered in Persia as well as in Iraq, so my quess is that wootz blades were part of Persian trade, and the fittings were added as part of local "customising". Does anyone has any references/comments about this? Good luck to all.