View Single Post
Old 22nd January 2020, 08:17 AM   #10
A. G. Maisey
Member
 
Join Date: May 2006
Posts: 6,675
Default

Forget the idea of "three pieces", just focus on time to make a forging from which a keris can be carved.

The bulk of time to make a keris with a plain mlumah pamor is in the carving.

Go here:-

http://www.kerisattosanaji.com/PBXIImaisey3.html

This keris was made 100% in Australia, at Wentworthville, I used a coke forge, I worked completely alone, no striker, no power hammer.

It was carved completely with manual tools, no electric tools.

It is not a mlumah pamor, I made a mlumah pamor then turned it side on so the central portion of the blade face is adeg, so there is a bit more forge time in it than if I had left it as a wos wutah.

Total working time was 16 days, at 6 and 8 hour days, say, +/- 110 to 120 manhours.

I do not recall exactly how long the forge time took, but it was probably about 3 days, give or take a bit. It is a normal, full size keris.


For comparison, this one:-

http://www.kerisattosanaji.com/PBXIImaisey2.html

was forged in Solo, working with two strikers, it took 3 days of forge work with two strikers, so 9 mandays. It was forged on charcoal, they were not 8 hour days, more like 6 hour days, or less. It is half size keris, and it is a manipulated (twisted) pamor.

I carved it in Australia, again, only manual tools, no electric tools, total working time was +/- 40 carving days + 9 mandays forging, total 49 mandays.
A. G. Maisey is offline   Reply With Quote