View Single Post
Old 4th August 2019, 09:39 AM   #10
chiefheadknocker
Member
 
Join Date: Dec 2014
Posts: 143
Default

Quote:
Originally Posted by Ian
You might try to etch it after warming the blade. Vinegar can be a weak etchant on some steels. Also, make sure there is no residual oil or wax on the blade before etching. Isopropyl alcohol is my preferred agent for cleaning off any oil or grease before etching.
Thanks ian , i have done as you said ,i have some isopropyl alcohol and so ive cleaned it well then heated the blade under hot water , i then cleaned it again whilst it was hot and used vinegar , but still it doesnt show much pattern of any kind , the steel seems very hard , when i first tried removing the rust it took a long time to get it off ,
what else would you recommend to etch it ?
regards
chief
chiefheadknocker is offline   Reply With Quote