Very often a hilt is simply a pressure fitting, where the tang is wound with thread, however, sometimes an old hilt can be difficult to remove for one reason or another, so I suggest that if the hilt will not turn off fairly easily, that you don't force it at this stage, just provide a couple of pics where we can see the shape of the gonjo on either side of the hilt. That should be sufficient.
The re-stain process can be a bit difficult, and to do it properly, you need a pretty high committment as well as access to arsenic, however, you may find that if you remove the hilt, give the blade a thorough wash with a toothbrush, hot water and detergent , then soak in ordinary household vinegar for a day or so, that you will be able to see the pamor clearly. It won't be as good as a proper restain, but it could well serve the purpose for you. Make sure to kill the vinegar by painting on a slurry of bicarbonate of soda, rinsing thoroughly and drying thoroughly, then drench with WD40 when you're finished.
|