View Single Post
Old 28th December 2017, 09:05 PM   #8
Ian
Vikingsword Staff
 
Ian's Avatar
 
Join Date: Dec 2004
Location: The Aussie Bush
Posts: 4,008
Default

Hello Kai,

Thanks for your thoughts. I think these are better pics of the defect and the end of the scabbard. The defect appears to be filled with resin.

Blade length = 10.5 inches
OAL = 15 inches
OAL in scabbard = 16 inches

Thickness of blade in front of hilt = 5/16 inch

Maximum blade width (at hilt) = 3/4 inch
Minimum blade width (near mid-point of blade) = 0.5 inch

The blade does taper towards the tip but not a great deal until about a half-inch from the tip where it tapers fairly acutely to the point. The sharpened edge starts about 3.5 inches from the hilt. For a blade that is not very wide it is quite sturdy and thick. Probably a good thrusting weapon.

Ian.

.
Attached Images
    

Last edited by Ian; 28th December 2017 at 09:20 PM.
Ian is offline   Reply With Quote