Ethnographic Arms & Armour - View Single Post

Gavin Nugent · 28th September 2008, 06:16 AM

I wont go there then Chris, I do remember the read quite some time ago,

As for these blades, they both share the fine edge from hilt to tip, but the spine tapers from 9mm at the hilt to just under 1mm at the point where the fullers end then it flares again ever so slightly to 1mm whilst continuing to the tip, all the time retaining the beautifuuly bevelled cutting edge the entire length.

regards

Gav

28th September 2008, 06:16 AM	#12
Gavin Nugent Member Join Date: Oct 2007 Posts: 2,818	I wont go there then Chris, I wont go there then Chris, I do remember the read quite some time ago, As for these blades, they both share the fine edge from hilt to tip, but the spine tapers from 9mm at the hilt to just under 1mm at the point where the fullers end then it flares again ever so slightly to 1mm whilst continuing to the tip, all the time retaining the beautifuuly bevelled cutting edge the entire length. regards Gav