View Single Post
Old 19th December 2004, 08:23 PM   #21
Battara
EAAF Staff
 
Battara's Avatar
 
Join Date: Dec 2004
Location: Louisville, KY
Posts: 7,135
Default

As you can see, one can be fooled because the metal is pushed back in parts allowing only the none hammered parts to remain looking like they are pushed out. It can become very confusing at times.

Another note: to repousse something one needs to use thinner sheet metal. Chasing, on the other hand, can be used on almost any thickness.
Battara is offline   Reply With Quote