Dear friends,
some monthes ago, I had been authorized by the forum administrators to show you a brand new
yatagan I had made, and I had chance to have some very interesting discussions with some of you about various issues concerning my work versus genuine ancient arms.
Today, I'm starting a new commission, a set of two caucasian arms, a kindjal and a shashka. First I shall be making the kindjal, and only after that the shashka.
I would greatly appreciate if I could discuss this work with you, just as we did for the yatagan, but doing it before I start would help me to avoid mistakes and solve some technical issues.
The kindjal is going to be plain carbon steel - no damascus - with satin polishing. The blade will have one non centered fuller and a wood or horn handle. The scabbard will be made of wood covered with leather. Both handle and scabbard will have some silver fittings with chasing / chiseling work and niello (and the same fittings will later be made for the shashka too).
My first issue is about the blade itself. I have no idea whether it should be flexible or not, and I don't know precisely what its thickness should be, from its base to its tip (distal tape).
From photos, I think it should be quite thick - but how thick exactly I can't say - and very unflexible... but I'm not sure to be right !
Would you be so kind to help me answer these very first questions ?
Thanks a lot for your help and advices, and kind regards,
Bernard