Ethnographic Arms & Armour - View Single Post

Mare Rosu · 13th February 2005, 07:03 PM

JENS and all others good forum folks.
A most interesting thread indeed. I find little to fault with all the input but I have a question: How can one have two or more magnetic poles on the same blade? If you use a file, hammering or other means to magnetize a blade on purpose or otherwise, would you not have just one pole a North and a South pole on the blade. It is hard for me to figure out a process that would magnetize a blade with more than one North,& South pole without doing so on purpose by someone along the way. Leaving it in one place even for hundreds of years would still give you just a North and a South pole.
So my take is that a blade with more than one North and one South pole must have been done so on purpose.
Gene
Sorry

Fearn got it right this time.

13th February 2005, 07:03 PM	#22
Mare Rosu Deceased Join Date: Dec 2004 Location: USA, DEEP SOUTH, GEORGIA, Y'all hear? Posts: 121	Question? JENS and all others good forum folks. A most interesting thread indeed. I find little to fault with all the input but I have a question: How can one have two or more magnetic poles on the same blade? If you use a file, hammering or other means to magnetize a blade on purpose or otherwise, would you not have just one pole a North and a South pole on the blade. It is hard for me to figure out a process that would magnetize a blade with more than one North,& South pole without doing so on purpose by someone along the way. Leaving it in one place even for hundreds of years would still give you just a North and a South pole. So my take is that a blade with more than one North and one South pole must have been done so on purpose. Gene Sorry Fearn got it right this time.