Hello Jose,
Quote:
I totally agree with the rubbing down with baking soda after the etch - this stops the continued etch and prevents eventual corrosion post etch.
|
Sure, with most acids a neutralization step is crucial. However, the main problem with ferric chloride is that it promotes corrosion even after full neutralization: any remaining chloride ions will act as catalyst for rusting. Forever! With many antique blades removing all chloride by rinsing/soaking is a real challenge if at all feasible!
BTW, the beauty of acetic acid (vinegar) is that any traces will evaporate upon gently heating the blade.
Regards,
Kai