Very good information that raises the question... who stamped the crosses and moon in these blades? On the one hand it looks like they were stamped in the metal with a die rather than etched. Can you stamp a cold steel blade, or does it have to be done while it's being forged? I guess you could heat it up to stamp it after the fact, but wouldn't that ruin the temper?
On the other hand, it sort of looks like this blade was cut down at both ends and where the current hilt is attached was once part of the blade. If the crosses were stamped into the blade when it was a longer sword, wouldn't that place them somewhere in the middle of the original blade? If that's the case then they may have been stamped at the time the blade was cut down.
|