Ethnographic Arms & Armour - View Single Post

pbleed · 22nd March 2021, 10:31 PM

Dear Friends,
I am a long-time lurker on the Ethnographic Arms and Armour Forum, but I have little skill in this medium, so I rarely have spoken up.
I write today because I am developing a paper on a couple of cannons that I think deserve documentation. I own them. They were brought to the US before America’s involvement in WWI by an early and distinguished officer in the Philippine Constabulary. They both exhibit an interesting break action design. And both are made of older bronze muzzle loading guns.
The smaller gun seems made to accept a 37mm shell. It has a very light inscription on the barrel extension that may say something like “El D??? Baro”. It also carries the number “3” on the wood base. The barrel measures 36.5 cm. I believe that this gun was made of a small Spanish cannon. I would appreciate suggestions and guidance on this topic.
The other gun seems to be a modified lantaka that was adjusted to accept a 1” (Nordenfelt?) round. The barrel is 77 cm long.
I would appreciate any and all advice, but I am especially interested in the break action design of these guns. Is this type at all common?
Thank you. If I can figure out how to do it, I will post some pictures
Peter Bleed

22nd March 2021, 10:31 PM	#1
pbleed Member Join Date: Jun 2005 Location: Little Rock, Arkansas Posts: 88	Filipino cannons Dear Friends, I am a long-time lurker on the Ethnographic Arms and Armour Forum, but I have little skill in this medium, so I rarely have spoken up. I write today because I am developing a paper on a couple of cannons that I think deserve documentation. I own them. They were brought to the US before America’s involvement in WWI by an early and distinguished officer in the Philippine Constabulary. They both exhibit an interesting break action design. And both are made of older bronze muzzle loading guns. The smaller gun seems made to accept a 37mm shell. It has a very light inscription on the barrel extension that may say something like “El D??? Baro”. It also carries the number “3” on the wood base. The barrel measures 36.5 cm. I believe that this gun was made of a small Spanish cannon. I would appreciate suggestions and guidance on this topic. The other gun seems to be a modified lantaka that was adjusted to accept a 1” (Nordenfelt?) round. The barrel is 77 cm long. I would appreciate any and all advice, but I am especially interested in the break action design of these guns. Is this type at all common? Thank you. If I can figure out how to do it, I will post some pictures Peter Bleed