Quote:
|
Originally Posted by drac2k
.... ;however after holding it under strong natural light, I can say that the center panel is indeed twist core.
I will not etch the blade, as I do not know what I am doing and would not risk harming it.
|
Hello Drac2k,
you couldn't harm the blade when you follow my advice: use a solution from 20% vinegar essence with water, heat it and brush the warm blade with a brush until you see the effect. When you don't like it you can scrub the blade with steel wool until the lamination effect is gone since the effect is only superficial, there isn't any risk to harm the blade, believe me. Don't forget to neutralize the blade with baking soda or soap. An only light scrub with steel wool give the blade back a shiny surface. When you never try it you never will learn it!
This blade is worth to show the twist core lamination.
Best regards,
Detlef