View Single Post
Old 16th September 2017, 03:58 PM   #12
Join Date: Jul 2010
Location: St. Louis, MO area.
Posts: 1,379

Originally Posted by corrado26
The hilts in the fotos above are IMO made of two pieces too. This is as I think necessary because only in this way you are able to bring a fitting piece of wood in the interior of the hilt.

Hi Corrado.

It appears the wood portion is one piece, with the two brass pieces installed over the wood and peened tight using a small brass cap on the end.

Since this knife is not very "old", I could take the option of having the wood portion replaced with a new piece of European walnut and reassemble offering a firm grip. Would not be a difficult job having the old wood as a pattern.

What do you guys think ?

Attached Images
rickystl is offline   Reply With Quote