Ethnographic Arms & Armour - View Single Post - confederate fascinemesser bizarre weld!!!!!!!!!!!!

tom hyle · 16th January 2005, 08:28 AM

I went to ebay to see if the two blades (did I mention the seller had a second, unmarked one?) are the same length; I figured that might help in the repair/vs/crude production question, but the seller has a very frustrating way of giving different measurements for each; one length in the sheath, one out......I know they're both 1 5/8" wide blades, but that doesn't help. The one good thing is the one he does give a blade only measurement of is this one (18 1/2"). That finger joint would cost you a good 3/4", I should think, if it is a repair. I'll try to remember to email Therion tomorrow to find out a measurement on his.

16th January 2005, 08:28 AM	#4
tom hyle Member Join Date: Dec 2004 Location: Houston, TX, USA Posts: 1,254	I went to ebay to see if the two blades (did I mention the seller had a second, unmarked one?) are the same length; I figured that might help in the repair/vs/crude production question, but the seller has a very frustrating way of giving different measurements for each; one length in the sheath, one out......I know they're both 1 5/8" wide blades, but that doesn't help. The one good thing is the one he does give a blade only measurement of is this one (18 1/2"). That finger joint would cost you a good 3/4", I should think, if it is a repair. I'll try to remember to email Therion tomorrow to find out a measurement on his.