View Single Post
Old 22nd November 2013, 08:26 PM   #20
Jean
Member
 
Join Date: Jun 2009
Posts: 1,740
Default

Quote:
Originally Posted by A. G. Maisey
To stain or not to stain?

The ivory hilted one I would probably give a good soak with WD40 or some other penetrating oil, then gentle selective cleaning with picks, a hard toothbrush and maybe a little bit of steel wool wound around the end of a sate stick. Wash with mineral turps and toothbrush, dry with hairdryer, drench again with WD40, allow to dry, then apply a long term protective oil and store in plastic film.

I find it advisable to use a 2X or 3X jeweler's loupe when doing this sort of work.

The horn hilted one I'd probably use a small acid brush and just apply the acid to the corroded areas. I'd probably use hydrochloric and I would not leave it to work and walk away, I'd be watching it while it worked. Then I'd pick the loose corrosion out of the pits and repeat and repeat until I got down to hard metal. When the corrosion was 99% gone it would get a light cleaning with vinegar or citric acid, get rinsed well, WD40 over night and protective oil and plastic film. I would not stain this second blade. Not if it was going into my own collection I wouldn't.
Hello Alan,
I am probably not careful or patient enough but all my attemps to selectively remove rust spots have ended with a brighter surface than the rest of the blade, so an unsatisfactory result.
John, I attach the pictures of a Sumatrese blade before and after cleaning & staining so you can better appreciate my position.
Best regards
Attached Images
  
Jean is offline   Reply With Quote