Ethnographic Arms & Armour

Ethnographic Arms & Armour (http://www.vikingsword.com/vb/index.php)
-   European Armoury (http://www.vikingsword.com/vb/forumdisplay.php?f=12)
-   -   Old handcannon with smaller breech (http://www.vikingsword.com/vb/showthread.php?t=30866)

Lead Snowstorm 20th August 2025 01:03 AM

Old handcannon with smaller breech
 
5 Attachment(s)
Greetings all - I recently obtained an old handcannon which appears to have some similarities to that discussed in this thread, c. 1350:

https://www.vikingsword.com/vb/showthread.php?t=12151

Pictures are attached below. It is mounted in a reproduction tiller stock. The caliber is approximately 4.4-4.5 cm; overall length of the barrel is about 29.2 cm. The breech (“pulverkammer”) is about 1/3 of the overall length. Interestingly, the touchhole appears angled slightly from the breech at the surface towards the muzzle at the inside. This merits further examination. I will try to get an X-ray of the barrel, but as I have access only to a medical-grade machine I may not have sufficient power to reveal any detail.

M ELEY 25th August 2025 06:49 PM

Hello and welcome to the Forum. I am a novice when it comes to these items and I know some of our old Forum folks that dealt with these extensively are unfortunately no longer with us.:( However, there are still a few out there and hopefully they will respond. I must say it is an amazing hand cannon and if you did the replacement work yourself, you did an amazing job! The angled touch hole does raise a few questions. I know with thunder mugs, the touch holes that had an angled 'pocket' for the powder/fuse were because they were signal cannon meant to be placed flat against the ground, thereby making the touch hole facing upwards. This cannon appears to be a true firearm with it's larger size, so I'm not necessarily suggesting it's a "mug", but again, maybe an expert will come through on this. Anyone??

Lead Snowstorm 26th August 2025 03:20 AM

Most of the noisemakers I’ve seen required a flash pan (as you mention) to hold the priming charge - this one doesn’t have a pan at all. And I must also admit I’ve not seen one of those upright noisemakers with a narrower breech - usually they were swamped wider at the breech to enable them to stand up. So I do agree this one is most likely not a thunder mug.

I cannot take credit for the stock - it came to me that way. I definitely agree, whoever made it did a great job!


All times are GMT +1. The time now is 08:25 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Posts are regarded as being copyrighted by their authors and the act of posting material is deemed to be a granting of an irrevocable nonexclusive license for display here.