blade

[galvano]

hi
Two old blades.
Origin?
Your opinion.
Thank you.
galvano

[ariel]

The blades look like Palestinian Shibriyas. How big are they?
Very peculiar...

[galvano]

Overall length 23 cm .
jordan ?
thank
galvano

[spiral]

Jordan,Israel,Palestine,Syria type area.

Spiral

[katana]

I have seen blades very similar to these , I'm afraid there is a possibillity that these are from an agricultural cutting machine or similar (combine harvester ?) ...they also had the 3 rivet holes

[spiral]

Any pix or links katana?

Spiral

[katana]

Hi Spiral,
I saw some similar to these at an auction....I thought they were unusual blades...because of the three 'fixing holes'. Luckily a 'farmer type' informed me they were 'cutters' from a farm machine.
I saw 3 'ethnic spearheads' on eBay, recently, with the same rivet hole pattern...but not with curved blades (long tapering triangle)....but these had remnants of green paint :eek:

I could be totally wrong about these....but the wear marks around the rivet holes suggests great force elongated the holes and ripped the rivets out....

Regards David

[ariel]

Come to think of it, you might be right: there still is a big lug nut in one of the holes. Where is the handle it was attached to? :D :D

[tom hyle]

I'd really like to see these industrial/powered blades that are being discussed. THese look like shabrias; an awful lot like shabrias. The holes appear, BTW, to have been hand-punched, not drilled, and this is responsible for the ridgelike formation around them. Note the marks at the blade base of the one which still contains a rivet (? does not look like a bolt to me?), and its hand forged shoulders. The other seems to have a groove running out the end of its handle; trick of the light? Corrosion?
The cross-section seems to be flattened diamond with rather fine edges, judging from the damage?

[katana]

.....a possibillity that these are from an agricultural cutting machine or similar (combine harvester ?) ...they also had the 3 rivet holes



I could be totally wrong about these....but the wear marks around the rivet holes suggests great force elongated the holes and ripped the rivets out....

Regards David

Note the marks at the blade base of the one which still contains a rivet (? does not look like a bolt to me?),

:confused:

EDITED Sorry Tom I have just realised you were refering to a bolt mentioned in another post on this subject. :o The missing 'tang' appears to have been 'sheared' off .....a lot of force would be required to have done this...