View Full Version : Taza Rapier for comment
Cerjak
31st May 2013, 11:25 AM
Hi everybody,
Here some pictures from my last acquisition a TAZA rapier.
The seller was not able to tell the me origin and only told me that it was a late 17 TH century sword.
I expect that one member could confirm me period and origin.
Regards
Cerjak
Cerjak
31st May 2013, 11:28 AM
more pictures
fernando
31st May 2013, 07:13 PM
Very nice sword.
Spanish ... Italian ?
Strange that the quillon ends are so simple, comparing to the sophistication of the whole guard.
Late 17th century seems to be O.K. :o
Make sure there is no smith's mark in any of the ricasso sides.
.
Valjhun
1st June 2013, 12:49 AM
Something odd about that piece, quillons as Fernando mentioned and the blade lenght also... it seems too short... what is its lengt?
Cerjak
1st June 2013, 09:18 AM
Dear Fernando
Yes there is something like smith's mark here but very dificult to see because of the cup ,I will try to find the way to put my eye there.
Regards
Cerjak
Cerjak
1st June 2013, 12:37 PM
Dear Fernando
Yes there is something like smith's mark here but very dificult to see because of the cup ,I will try to find the way to put my eye there.
Regards
Cerjak
here some extra close up pictures but from photos it will be very hard to see something ....
Cerjak
1st June 2013, 12:41 PM
Something odd about that piece, quillons as Fernando mentioned and the blade lenght also... it seems too short... what is its lengt?
Hi Valjhun
Total size Around 100 cm so could be shorter than is genuine size ...
Regards
Cerjak
fernando
1st June 2013, 02:03 PM
here some extra close up pictures but from photos it will be very hard to see something ....
However there is a mark there; some relieve is visible ;) .
fernando
1st June 2013, 02:04 PM
Hi Valjhun
Total size Around 100 cm so could be shorter than is genuine size ...
Regards
Cerjak
Not necessarily. Some cup hilt swords have such length; i have a couple myself.
VANDERNOTTE
1st June 2013, 10:24 PM
i have one similar. the blade is marked " SEBASTIAN HERNANDEZ"
maby is a victorian copy?????
sword 115 cm
blade 98 cm
regard
jacques
fernando
2nd June 2013, 01:19 PM
i have one similar. the blade is marked " SEBASTIAN HERNANDEZ"
maby is a victorian copy?????
Similar ... but not that much :o .
... and what makes you think it is a Victorian copy, Jacques ? :confused: -
Can you give a clue ?
.
VANDERNOTTE
2nd June 2013, 07:59 PM
maestro fernando
he ahi mis alegatos
1)no smith mark
2)no cabala
3) the blade is thick whis no flexibility
4)i suspect the screws and thread ar not correct
5)the sword don't look 300 years old
6) my feeling
que tengas un lindo domingo
regard
jacques
Dmitry
6th June 2013, 05:49 PM
I like the 2nd sword, the 1st sword...those quillons are funky. It must've belonged to a ninja.
Why would someone remove both quillon terminals and sharpen the ends? I don't think I remember seeing something like that.
The owner of this sword was one bad hombre. :)
Cerjak
19th June 2013, 02:09 PM
Hi Dmitry
Possible that someone remove both quillon terminals and sharpen the ends but in this case may be it was more efficient during the fight ...
Dmitry
24th June 2013, 03:09 PM
Bonjour, Cerjak.
That is possible, but how would he wear the sword when he wasn't fighting, but going for a leisurely stroll ? The sharp quillons would surely stab him when he walked, rip his clothing, as well as other people that he passed by on the narrow streets. Unless they were covered with some type of removable caps...
It's a tough one. I figure we'd see other period swords with sharpened quillons. Imho they were as dangerous for other people, as they were for the owner, if he were to use that sword for what it was meant to do.
:shrug:
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.