Log in

View Full Version : Vere daggers ? (pls help with ID)


Martin Lubojacky
11th November 2010, 10:50 AM
These daggers vere recently acquired in Cameroon. I think it could be Vere (?), but there are another similar tribes in the area. There are clear signs of long-term use on the hilts and sheaths, especially pommel of the smaller dagger is smoothed out. Blades are strong, of lenticular (bigger) and rhombic (smaller) crossection, but the blade of the bigger dagger (total length cc 60 cm) is a little bit more rough. The question is also - why the blade is so short ?
The sheaths and parts of the hilts are brass cast, the "walls" are surprisingly thin.
I cleaned them - I hope it was not a mistake (I think brass could be cleaned in this cases).
Martin

Tim Simmons
11th November 2010, 06:46 PM
Very nice. The large one is particulary nice. You might find this interesting from back in the good old days.

http://www.vikingsword.com/vb/showthread.php?t=3626&highlight=african+lance

Martin Lubojacky
11th November 2010, 11:06 PM
Many thanks Tim. I have always been saying old good witness is uncoverable
Martin

VANDOO
12th November 2010, 05:38 AM
THESE ARE NOT EXACTLY THE SAME AS YOUR EXAMPLES BUT FROM NIGERIA/CAMEROON BUT PERHAPS MORE CEREMONIAL OR PRESTIEGE THAN FOR ACTUAL USE.
IF I REMEMBER CORRECTLY THE TWO SWORDS ARE FROM A FORUM MEMBER IN AN OLD POST. SWORD 97CM LONG

Martin Lubojacky
13th November 2010, 05:23 PM
Thank you, Vandoo.
Martin